Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function)

REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function) > Release Actuator Circuit

for Preparation Click here


DESCRIPTION

The fold seat control ECU receives a switch operation signal from the fold seat switch and activates the release actuator. The release actuator releases the lock of the stowed seat based on a drive voltage received from the ECU.

WIRING DIAGRAM


B129644E02


INSPECTION PROCEDURE

1.INSPECT FOLD SEAT CONTROL ECU


    B129650E47
  1. Remove the fold seat control ECU with connector still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    P63-3 (RACT) - Body ground
    Stowing/Return switch: RETURN
    10 to 14 V
    RH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    P65-3 (RACT) - Body ground
    Stowing/Return switch: RETURN
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)


    B129659E22
  1. Disconnect the connectors from the fold seat control ECU.

  1. Disconnect the connector from the folding motor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P63-3 (RACT) - F22-9 (RACT)
    Always
    Below 1 Ω
    P63-3 (RACT) - Body ground
    Always
    10 kΩ or higher
    RH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P65-3 (RACT) - F23-9 (RACT)
    Always
    Below 1 Ω
    P65-3 (RACT) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (FOLDING MOTOR - BODY GROUND)


    B129662E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    F22-2 (E2) - Body ground
    Always
    Below 1 Ω
    RH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    F23-2 (E2) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE