Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function)

REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function) > Lock Switch Circuit

for Preparation Click here


DESCRIPTION

Each of the left and right seats has lock switches that detect the lock condition of the seat legs to the floor when the seat is in the original or folded-down state. If any of the lock switches detect an unlock condition, the 3rd SEAT indicator on the combination meter will come on and the folding-down, return, and reclining operations will be disabled.

WIRING DIAGRAM


B129647E02


INSPECTION PROCEDURE

1.INSPECT FOLD SEAT CONTROL ECU


    B129650E51
  1. Remove the fold seat control ECU with connector still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH side 
    Tester connection
    (Symbol)
    Condition
    Specified condition
    P62-38 (LCKF) - Body ground
    Any of the lock switches: UNLOCK
    Below 1 V
    P62-38 (LCKF) - Body ground
    All lock switches: LOCK
    10 to 14 V
    RH side 
    Tester connection
    (Symbol)
    Condition
    Specified condition
    P64-38 (LCKF) - Body ground
    Any of the lock switches: UNLOCK
    Below 1 V
    P64-38 (LCKF) - Body ground
    All Lock switches: LOCK
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - LOCK SWITCH)


    B129659E23
  1. Disconnect the connectors from the fold seat control ECU.

  1. Disconnect the connector from the lock switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    P62-38 (LCKF) - F22-12 (LCKF)
    Always
    Below 1 Ω
    P62-38 (LCKF) - Body ground
    Always
    10 kΩ or higher
    RH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    P64-38 (LCKF) - F23-12 (LCKF)
    Always
    Below 1 Ω
    P64-38 (LCKF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (LOCK SWITCH - BODY GROUND)


    B129662E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    F22-1 (E) - Body ground
    Always
    Below 1 Ω
    RH side 
    Tester connection
    (Symbols)
    Condition
    Specified condition
    F23-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE LOCK SWITCH

HINT:
Since the lock switch cannot be inspected while it is removed from the vehicle, replace the lock switch with a normal one and check that the condition returns to normal.

OK:
Same problem does not occur.



OK
END
NG

REPLACE FOLD SEAT CONTROL ECU