Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)


    I035952E01
  1. Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.



2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System)


    I035953E01
  1. Disconnect the connector and remove the No. 1 ultrasonic sensor.



3. REMOVE REAR BUMPER ENERGY ABSORBER


4. REMOVE REAR BUMPER BAR PLATE
  1. Remove the 4 clips and the rear bumper bar plate.



5. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY
  1. Remove the 6 nuts and the rear bumper reinforcement sub-assembly.



6. REMOVE LH REAR BUMPER SIDE RETAINER
  1. Remove the 3 screws and the LH rear bumper side retainer.



7. REMOVE RH REAR BUMPER SIDE RETAINER
  1. Remove the 3 screws and the RH rear bumper side retainer.