Home › BODY › EXTERIOR › REAR BUMPER

REAR BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL LH REAR BUMPER SIDE RETAINER
  1. Install the LH rear bumper side retainer with the 3 screws.



2. INSTALL RH REAR BUMPER SIDE RETAINER
  1. Install the RH rear bumper side retainer with the 3 screws.



3. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY
  1. Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



4. INSTALL REAR BUMPER BAR PLATE
  1. Install the rear bumper bar plate to the rear bumper reinforcement sub-assembly with the 4 clips.



5. INSTALL REAR BUMPER ENERGY ABSORBER


6. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System)
  1. Connect the connector and install the No. 1 ultrasonic sensor.



7. INSTALL NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)
  1. Install the No. 1 ultrasonic sensor retainer.