Home › BODY › EXTERIOR › FRONT DOOR GLASS WEATHERSTRIP

FRONT DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    B067483E01
  1. Using a screwdriver, disengage the clip and claw, and remove the garnish.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    B062416E01
  1. Using a screwdriver, disengage the 3 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY


4. REMOVE BACK FRAME PLATE


5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B067486E01
  1. Remove the screw.

  1. Using a screwdriver, disengage the clip and claw, and remove the armrest base panel upper together with the switch.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connector.

  1. Remove the 3 screws and switch from the armrest base panel upper.

  1. Using pliers, remove the 2 pins and armrest.



6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    B067922
  1. Remove the 3 screws and back frame plate.



    B067485E01
  1. Remove the 2 cushion rubbers.

  1. Remove the 2 screws and the clip A.

  1. Using a screwdriver, disengage the other 9 clips.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the trim board upward.

    HINT:
    In order to prevent the door panel from being damaged, cover the areas indicated by arrow marks in the illustration with protective tape.



    B066961E01
  1. Disconnect the 2 cables from the inside handle, as shown in the illustration.

  1. Using a screwdriver, disengage the 10 hooks and remove the weatherstrip inner.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the 2 screws and inside handle.



7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    B062419
  1. Disconnect the connector.

  1. Remove the 3 nuts and mirror.



8. REMOVE FRONT DOOR GLASS WEATHERSTRIP


    B067630E01
  1. Put protective tape under the front door glass weatherstrip.

  1. Using a screwdriver or moulding remover, remove the front door glass weatherstrip.

    HINT:
    Tape the screwdriver tip before use.