Home › BODY › EXTERIOR › REAR DOOR GLASS WEATHERSTRIP

REAR DOOR GLASS WEATHERSTRIP > REMOVAL

for Preparation Click here



1. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY


2. REMOVE REAR DOOR WINDOW FRAME SUB-ASSEMBLY


3. REMOVE SIDE TRIM BOARD COVER REAR


    B206564
  1. Remove the 2 screws.

  1. Using a screwdriver, disengage the 9 claws and remove the rear side trim board cover LH.

    HINT:
    Tape the screwdriver tip before use.



    B206562
  1. Remove the 2 screws and rear door trim bracket LH.



    B206563
  1. Using a screwdriver, disengage the 2 claws and remove the rear power window regulator switch assembly.



4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B069309E01
  1. Remove the screw.

  1. Using a screwdriver, disengage the 9 clips and remove the trim board.

    HINT:
    1. Tape the screwdriver tip before use.
    2. In order to prevent the door panel from being damaged, cover the areas with protective tape as indicated by arrow marks in the illustration.

  1. Using a clip remover, remove the 6 clips and weatherstrip No. 2.

  1. Using a screwdriver, disengage the 11 claws and remove the weatherstrip inner from trim board.

    HINT:
    Tape the screwdriver tip before use.



    B069307E01
  1. w/ Sunshade:
    Remove the sunshade.

    1. Remove the 7 screws and sunshade bezel.

    2. Remove the 4 screws and curtain.



5. REMOVE REAR DOOR GLASS RUN


6. REMOVE SLIDE DOOR WINDOW ASSEMBLY


    B069208
  1. w/ Sunshade:
    Remove the sunshade hook.

  1. Remove the bolt and window frame.



    B067495E01
  1. Remove the bolt.

  1. Loosen the nut.

  1. Push the window frame rear lower in the direction indicated by the arrow mark in the illustration.



    B067494
  1. Remove the 2 hole plugs.

  1. Move the window until the bolts appear in the service holes.

    NOTICE:
    1. Do not damage the window assembly.
    2. When the bolts are removed, the window assembly may fall and become deformed.

  1. Remove the 2 bolts and window.



7. REMOVE REAR DOOR GLASS WEATHERSTRIP


    B067631E01
  1. Put protective tape under the rear door glass weatherstrip.

  1. Using a screwdriver or moulding remover, remove the rear door glass weatherstrip.

    HINT:
    Tape the screwdriver tip before use.