Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B067736E01
  1. Put protective tape around the roof drip side finish moulding.

  1. Using a remover for the roof moulding, disengage of the clips both in the front and rear ends of the roof drip side finish moulding and then remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. If the clips are damaged or removed accidentally, exchange them for supply ones.