OUTSIDE MOULDING > INSTALLATION |
| 1. INSTALL OUTSIDE MOULDING |
Using a heat light, heat the mounting surface of the vehicle body between 40 to 60 °C (104 to 140 °F).
Remove the tape from the vehicle body.
Wipe off the stains with cleaner.
Clean the outside moulding (if reusing the outside moulding)
Using a heat light, heat the outside moulding between 20 to 30 °C (68 to 86 °F).
Remove the tape from the outside moulding.
Wipe off the stains with cleaner.
Apply new tape to the outside moulding as shown in the illustration.

Match the reference pins on the outside moulding with the reference holes on the vehicle body.
Using a heat light, heat the vehicle body and outside moulding.
| Body | 40 to 60 °C (104 to 140 °F) |
| Moulding | 40 to 60 °C (104 to 140 °F) |
Release the peeling paper from the face of the outside moulding and attach the outside moulding securely to the vehicle body.
Push the outside moulding to the body.