Home › BODY › EXTERIOR › OUTSIDE MOULDING

OUTSIDE MOULDING > REMOVAL

for Preparation Click here



1. REMOVE OUTSIDE MOULDING


    B050319E01
  1. Put protective tape around the outside moulding.

  1. Using a heat light, heat the moulding between 40 to 60 °C (104 to 140 °F).

    NOTICE:
    Do not heat the moulding excessively.

  1. Tie both piano wire ends to a wooden block or a similar object.

  1. Cut off the tape by pulling the piano wire and remove the outside moulding with reference pins remaining on the moulding.

    NOTICE:
    1. If reusing the outside moulding, take care not to damage the outside moulding.
    2. Do not damage the body.
    3. Be careful of the reference pins on the outside moulding when removing the outside moulding.