BACK DOOR OUTSIDE GARNISH > REMOVAL |
| 1. REMOVE BACK DOOR CENTER GARNISH |
![]() |
Using a clip remover, disengage the 5 clips to remove the back door center garnish.
| 2. REMOVE POWER BACK DOOR ROD |
![]() |
Remove the 2 clips and rod.
| 3. REMOVE BACK DOOR LH SIDE GARNISH |
Using a clip remover, disengage the 3 clips and remove the side garnish.
| 4. REMOVE BACK DOOR RH SIDE GARNISH |
Using a clip remover, disengage the 3 clips and remove the side garnish.
| 5. REMOVE BACK DOOR PULL STRAP |
![]() |
Using a screwdriver, disengage the 3 claws and remove the strap cover.
Remove the bolt and strap.
| 6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Using a screwdriver, disengage the 14 clips and remove the trim board.
| 7. REMOVE LH BACK-UP LIGHT ASSEMBLY |
![]() |
Disconnect the connector.
Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.
| 8. REMOVE RH BACK-UP LIGHT ASSEMBLY |
![]() |
Disconnect the connector.
Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.
| 9. REMOVE BACK DOOR OUTSIDE GARNISH |
Disconnect the licence light connector.
Remove the 5 nuts, clip and back door outside garnish sub-assembly.

![]() |
Remove the 2 screws and back door outside opener switch.