Home › ENGINE › 2GR-FE EMISSION CONTROL › AIR FUEL RATIO SENSOR (for 4WD)

AIR FUEL RATIO SENSOR (for 4WD) > INSPECTION

for Preparation Click here



1. INSPECT AIR FUEL RATIO SENSOR


    A194014E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (HT) - 2 (+B)
    20°C (68°F)
    1.8 to 3.4 Ω
    1 (HT) - 4 (AF-)
    Always
    10 kΩ or higher

    If the resistance is not as specified, replace the sensor.