Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR SCUFF PLATE


    B066493E01
  1. Using a screwdriver, disengage the 8 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE REAR DOOR WEATHERSTRIP

HINT:
When reinstalling the weatherstrip, completely remove the sealer adhering to the opening flange on the body side beforehand.



3. REMOVE BACK DOOR WEATHERSTRIP


4. REMOVE BACK DOOR SCUFF PLATE


    B066499E01
  1. Remove the 3 bolts.

  1. Using a screwdriver, disengage the 6 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY


    B066511
  1. Remove the floor anchor cover.

  1. Remove the bolt and disconnect the No. 2 rear seat outer belt assembly on the floor anchor side.

  1. Remove the 2 package holder net hooks.

  1. Using a screwdriver, disengage the claw and remove the courtesy light.

  1. Disconnect the courtesy light connectors.



    B066503E01
  1. Using a screwdriver, disengage the 16 clips and remove the quarter trim panel assembly.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE REAR WINDOW SIDE GARNISH ASSEMBLY


    B068595E01
  1. Remove the bolt and screw.

  1. 7-passenger:
    Using a screwdriver, disengage the 4 clips and remove the window side garnish assembly.

    HINT:
    Tape the screwdriver tip before use.

  1. 8-passenger:
    Using a screwdriver, disengage the 4 clips and 4 claws, and remove the window side garnish assembly.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 7-Passenger)

HINT:
Refer to the instructions for disassembly of the rear No. 1 seat assembly (for captain seat type) (Click here).

  1. Remove the rear seatback board RH.

  1. Remove the rear seat shoulder belt cover.

  1. Remove the bolt, nut and No. 1 rear seat outer belt assembly.



8. REMOVE 3 POINT TYPE REAR SEAT BELT ASSEMBLY (for 8-Passenger)
  1. Remove the nut and disconnect the 3 point type rear seat belt on the shoulder anchor side.



9. REMOVE NO. 2 REAR SEAT OUTER BELT ASSEMBLY


    B066510
  1. Using a screwdriver, disengage the 2 claws and remove the cover of the No. 2 rear seat outer belt assembly on the shoulder anchor side.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and disconnect the No. 2 rear seat outer belt assembly on the shoulder anchor side.

  1. Remove the bolt on the retractor side and remove the No. 2 rear seat outer belt assembly.