Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › NO. 1 ULTRASONIC SENSOR

NO. 1 ULTRASONIC SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 ULTRASONIC SENSOR
  1. Connect the connector and install the No. 1 ultrasonic sensor.



2. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
  1. Install the No. 1 ultrasonic sensor retainer.



3. INSTALL REAR BUMPER COVER


    B067544E01
  1. Install the rear bumper cover with the 2 screws and 8 clips.



4. INSTALL FRONT BUMPER COVER


    B125282
  1. Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Connect the connectors if necessary.



    B125280
  1. Install the 5 clips.



    B125279
  1. Connect the engine under cover to the front bumper assembly with the 8 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62.0 in.*lbf }



    B125278
  1. Connect the fender liner to the front bumper assembly with the 4 screws.



5. INSTALL FRONT FENDER LINER LH


6. INSTALL FRONT FENDER LINER RH