Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › NO. 1 ULTRASONIC SENSOR

NO. 1 ULTRASONIC SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER LINER LH


2. REMOVE FRONT FENDER LINER RH


3. REMOVE FRONT BUMPER COVER


    B125278
  1. Remove the 4 screws and separate the fender liner from the front bumper assembly.



    B125279
  1. Remove the 8 screws and separate the engine under cover from the front bumper assembly.



    B125280
  1. Remove the 5 clips.



    B125281
  1. Disengage the claws on the left and right sides of the front bumper and pull the front bumper toward the front of the vehicle as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Disconnect the connectors if necessary.



4. REMOVE REAR BUMPER COVER


    B067544E01
  1. Put protective tape under the quarter panel.

  1. Partially the fender liner.

    HINT:
    Do not remove the fender liner completely but partially so that the bumper cover can be removed.

  1. Remove the 2 screws and 8 clips.

  1. Using a screwdriver, disengage the claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    I035952E01
  1. Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.



6. REMOVE NO. 1 ULTRASONIC SENSOR


    I035953E01
  1. Disconnect the connector and remove the No. 1 ultrasonic sensor.