Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › NO. 2 ULTRASONIC SENSOR

NO. 2 ULTRASONIC SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER COVER


    B067544E01
  1. Put protective tape under the quarter panel.

  1. Partially the fender liner.

    HINT:
    Do not remove the fender liner completely but partially so that the bumper cover can be removed.

  1. Remove the 2 screws and 8 clips.

  1. Using a screwdriver, disengage the claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER


    I035596
  1. Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.



3. REMOVE NO. 2 ULTRASONIC SENSOR


    I032670
  1. Disconnect the connector and remove the No. 2 ultrasonic sensor.