Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION RECEIVER

NAVIGATION RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT CLUSTER NO.1 FINISH PANEL CENTER


    B067329E01
  1. Using a moulding remover, disengage the 3 clips as shown in the illustration.

  1. Disconnect the connector and remove the instrument cluster finish panel center No. 1.



2. REMOVE INSTRUMENT CLUSTER NO.2 FINISH PANEL CENTER


3. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B067325E01
  1. Insert the edge of a moulding remover between the instrument cluster finish panel garnish and the radio receiver from the top center, and then lean the moulding remover toward the front of the vehicle to raise the instrument cluster finish panel garnish.

  1. Disengage the claw on the top of the instrument cluster finish panel garnish and the two clips from the radio receiver.



    B067326
  1. Pull up the instrument cluster finish panel garnish to the front of the vehicle to disengage the 5 claws at the bottom of the instrument cluster finish panel garnish.

  1. Remove the instrument cluster finish panel garnish.



4. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


    I035557E01
  1. Remove the 4 screws.

  1. Disconnect the connector and remove the navigation receiver assembly with bracket.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL UPPER


    I035560E01
  1. Remove the 4 screws and the instrument cluster finish panel upper.



6. REMOVE NO.1 NAVIGATION BRACKET


    I035559E01
  1. Remove the 4 screws and the No.1 navigation bracket.



7. REMOVE NO.2 NAVIGATION BRACKET


    I035558E01
  1. Remove the 4 screws and the No.2 navigation bracket from the navigation receiver assembly.