Home › BODY ELECTRICAL › AUDIO / VISUAL › INSTRUMENT PANEL SPEAKER

INSTRUMENT PANEL SPEAKER > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B067325E01
  1. Insert the edge of a moulding remover between the instrument cluster finish panel garnish and the radio receiver from the top center, and then lean the moulding remover toward the front of the vehicle to raise the instrument cluster finish panel garnish.

  1. Disengage the claw on the top of the instrument cluster finish panel garnish and the two clips from the radio receiver.



    B067326
  1. Pull up the instrument cluster finish panel garnish to the front of the vehicle to disengage the 5 claws at the bottom of the instrument cluster finish panel garnish.

  1. Remove the instrument cluster finish panel garnish.



2. REMOVE STEREO COMPONENT SPEAKER ASSEMBLY


    I035563
  1. Remove the 2 screws.

  1. Disconnect the connector and remove the stereo component speaker assembly.



3. REMOVE INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY


    B067327E01
  1. Using a screwdriver, disengage the 2 clips and remove the instrument panel speaker panel sub-assembly.



4. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    I035562
  1. Disconnect the connector and remove the 2 screws and the front No. 2 speaker assembly.