Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear safety gloves, because the sharp surfaces of the seatback frame and seat adjuster may injure your hand.
  2. Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
    (The SRS is equipped with a back-up power source. If work is stated within 90 seconds from disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT:
Use the same procedures for the RH side and LH side.



1. REMOVE FRONT SEAT HEADREST ASSEMBLY


2. REMOVE FRONT SEAT ASSEMBLY LH


    B089353
  1. Using a screwdriver, pry out the 2 seat track covers.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors under the seat assembly.

  1. Remove the 4 bolts and the seat assembly.

    NOTICE:
    Be careful not to damage the body.