Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Flat Type)

FRONT SEAT ASSEMBLY (for Flat Type) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY RH
  1. Place the seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the body.

  1. Connect the connectors under the seat assembly.

  1. Tighten the 2 bolts on the front side of the seat assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Tighten the 2 bolts on the rear side of the seat assembly.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Install the 2 track covers.



2. INSTALL FRONT SEAT HEADREST ASSEMBLY


3. CHECK SRS WARNING LIGHT

HINT:
Click here



4. CHECK SEAT SLIDE ADJUSTER LOCKS


    B113023E01
  1. Check the basic functions.

    1. Operate the power seat switches and check the following seat functions:

      1. Sliding
      2. Reclining
      3. Front vertical (Driver side seat only)
      4. Lifter (Driver side seat only)
      5. Lumbar support (Driver side seat only)



5. INITIALIZE OCCUPANT CLASSIFICATION SYSTEM

HINT:
Click here