REAR NO. 1 SEAT ASSEMBLY (for Center Seat) > REASSEMBLY |
| 1. INSTALL NO. 1 SEAT CUSHION FRAME SUB-ASSEMBLY |
Install the seat cushion frame with the bolt.
| 2. INSTALL RECLINING CONTROL LINK SUB-ASSEMBLY |
Install the reclining control link with the E-ring.
Install the nut.
| 3. INSTALL REAR SEAT TRACK ADJUSTING HANDLE |
Install the seat track adjusting handle.
| 4. INSTALL REAR SEAT RECLINING ADJUSTER ASSEMBLY RH |
Install the seat reclining adjuster with the bolt.
| 5. INSTALL NO. 1 REAR SEAT BELT ASSEMBLY OUTER RH |
Install the reclining sensor together with the seat belt with the nut.
| 6. INSTALL RECLINING CONNECTING PIPE |
| 7. INSTALL REAR SEAT RECLINING ADJUSTER ASSEMBLY LH |
Install the seat reclining adjuster with the bolt.
Install the reclining remote control cable.
| 8. INSTALL REAR SEAT HINGE COVER |
Install the seat hinge cover with the screw.
| 9. INSTALL REAR SEAT HINGE COVER LH |
Install the seat hinge cover with the screw.
| 10. INSTALL NO. 1 SEATBACK FRAME SUB-ASSEMBLY |
Install the seatback frame with the bolt.
Install the seat belt retractor with the nut.
| 11. INSTALL REAR SEAT SHOULDER BELT COVER RH |
Install the seat shoulder belt cover with the 2 screws.
| 12. INSTALL NO. 1 SEAT CUSHION COVER SUB-ASSEMBLY |
![]() |
Install the seat cushion pad to the seat cushion cover.
Using hog ring pliers, install the seat cushion cover to the seat cushion pad with new hog rings.
| 13. INSTALL REAR SEATBACK COVER |
![]() |
Install the seatback pad.
Using hog ring pliers, install the seatback cover completely with new hog rings.
![]() |
Attach a rubber wire with new hog rings, as shown in the illustration.
Using hog ring pliers, install new hog rings.
Install the 2 headrest supports.
| 14. INSTALL REAR SEATBACK LOCK BEZEL UPPER |
Install the rear seatback lock bezel upper.
Install the clip and screw.
| 15. INSTALL REAR SEATBACK BOARD |
Install the seatback board with the 2 screws.
Install the rear seatback board cap.
| 16. INSTALL FOLD SEAT STOPPER BAND ASSEMBLY |
Install the fold seat stopper band with the screw.
| 17. INSTALL REAR SEAT LAP TYPE BELT ASSEMBLY CENTER |
Install the lap type belt with the bolt.
| 18. INSTALL RECLINING ADJUSTER COVER RH |
Install the reclining adjuster cover.
Install the 3 screws.
| 19. INSTALL RECLINING ADJUSTER INSIDE COVER LH |
Install the reclining adjuster inside cover.
Install the 3 screws.
| 20. INSTALL RH SEAT REAR SEAT LOCK COVER |
Install the seat lock cover with the screws.
| 21. INSTALL LH SEAT REAR SEAT LOCK COVER |
Install the LH seat rear seat lock cove with the 2 screws.
| 22. INSTALL REAR SEAT LEG SIDE COVER LH |
Install the rear seat leg side cover with the 2 screws.
| 23. INSTALL REAR SEAT LEG COVER RH |
Install the rear seat leg cover RH with the 2 screws.
| 24. INSTALL REAR SEAT LEG COVER LH |
Install the rear seat leg cover LH with the 2 screws.