Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type RH Side)

REAR NO. 2 SEAT ASSEMBLY (for Manual Seat Type RH Side) > INSTALLATION

for Preparation Click here



1. INSTALL REAR NO. 2 SEAT ASSEMBLY RH
  1. Place the rear No. 2 seat assembly RH in the cabin.

    NOTICE:
    Be careful not to damage the body.

  1. Install the seat with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Install the locus cable RH with the bolt.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }

  1. Install the rear seat headrest assembly RH.

    HINT:
    Check that the seat leg locks.



2. INSTALL REAR SEAT LEG SIDE GARNISH SUB-ASSEMBLY RH
  1. Install the rear seat leg side garnish sub-assembly RH.