Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


NOTICE:
  1. Always wear safety gloves because the edges of the seatback frame and seat adjuster are sharp and may cause injury.
  2. Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.
    (The SRS is equipped with a back-up power source. If work is started within 90 seconds from disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT:
Use the same procedures for the RH side and LH side.



1. REMOVE FRONT SEAT HEADREST ASSEMBLY


2. REMOVE FRONT SEAT ASSEMBLY LH


    B089352
  1. Using a screwdriver, pry out the 2 seat track covers.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the connectors under the seat.

  1. Remove the 4 bolts and the seat assembly.

    NOTICE:
    Be careful not to damage the body.