RADIO ANTENNA CORD > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY |
| 2. REMOVE ANTENNA CORD SUB-ASSEMBLY |
Replace the 5 clamps and remove the antenna cord sub-assembly.

| 3. REMOVE PULL TOP ANTENNA POLE SUB-ASSEMBLY |
![]() |
Remove the pull top antenna pole sub-assembly by pulling it the arrow direction in the illustration.
| 4. REMOVE ANTENNA ORNAMENT |
![]() |
Remove the antenna ornament.
| 5. REMOVE ANTENNA ASSEMBLY WITH HOLDER |
![]() |
Disconnect the connector and remove the bolt.
![]() |
Tie the string at the tip of the cable of the antenna assembly with holder.
![]() |
Remove the nut and the antenna assembly with holder.
| 6. REMOVE ROOF HEADLINING ASSEMBLY |
| 7. REMOVE AMPLIFIER ANTENNA ASSEMBLY |
Disconnect the connectors.
Remove the 3 bolts.

Disengage the 16 clamps and remove the amplifier antenna assembly.