STEERING PAD SWITCH > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE STEERING WHEEL NO. 2 LOWER COVER |
Using a screwdriver, remove the steering wheel No.2 cover lower.
| 3. REMOVE STEERING WHEEL NO. 3 LOWER COVER |
Using a screwdriver, remove the steering wheel No.3 cover lower.
| 4. REMOVE HONE BUTTON ASSEMBLY |
![]() |
Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.
![]() |
Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
Remove the steering pad.
| 5. REMOVE STEERING PAD SWITCH LH |
![]() |
Disconnect the connector.
Disconnect the connector of cruise control main switch.
Remove the screw.
w/o Laser radar cruise control:
![]() |
Release the 2 pin fittings and remove the steering pad switch LH.
![]() |
w/ Laser radar cruise control:
Remove the clamp.
w/ Laser radar cruise control:
Release the 2 pin fittings and release the steering pad switch LH from steering wheel.
w/ Laser radar cruise control:
![]() |
Release the tab of steering pad switch cable from steering pad switch LH as shown in the illustration.
w/ Laser radar cruise control:
![]() |
Disengage the 2 claws as shown in the illustration and open the latch on the top of the connector.
w/ Laser radar cruise control:
![]() |
Pull out the connector while pinching the latch with fingers and disconnect the steering pad switch cable from the steering pad switch LH.