Home › BODY ELECTRICAL › OTHER SYSTEM › VOLTAGE INVERTER

VOLTAGE INVERTER > REMOVAL

for Preparation Click here



1. REMOVE REAR DOOR SCUFF PLATE LH


    B066493E01
  1. Using a screwdriver, disengage the 8 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



2. REMOVE REAR DOOR WEATHERSTRIP LH

HINT:
When reinstalling the weatherstrip, completely remove the sealer adhering to the opening flange on the body side beforehand.



3. REMOVE BACK DOOR WEATHERSTRIP


4. REMOVE BACK DOOR SCUFF PLATE


    B066499E01
  1. Remove the 3 bolts.

  1. Using a screwdriver, disengage the 6 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH


    B066511
  1. Remove the floor anchor cover.

  1. Remove the bolt and disconnect the rear No. 2 seat belt on the floor anchor side.



    B066503E01
  1. Remove the 2 package holder net hooks.

  1. Using a screwdriver, disengage the claw and remove the courtesy light.

  1. Disconnect the courtesy light connectors.

  1. Using a screwdriver, disengage the 16 clips and remove the quarter trim panel assembly.

    HINT:
    Tape the screwdriver tip before use.



6. REMOVE VOLTAGE INVERTER ASSEMBLY
  1. Disconnect the connector.



    I035567
  1. Remove the 2 bolts and the voltage inverter assembly.