Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM


E125108E02


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER


    E120048E02
  1. Disconnect the stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    GND - Body ground
    Always
    Below 1 Ω
    GND2 - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    B2+ - GND
    Always
    10 to 14 V
    B+ - GND
    Always
    10 to 14 V
    ACC - GND
    Ignition SW ACC
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE