NAVIGATION SYSTEM > Speaker Circuit |


| 1.CHECK HARNESS AND CONNECTOR |
![]() |
Disconnect the connectors shown in the illustration on the left from the stereo component amplifier and speakers.
Measure the resistance between the front No. 2 speakers and the stereo component amplifier to check for an open circuit in the wire harness.
Measure the resistance between rear speakers and the stereo component amplifier to check for an open circuit in the wire harness.
Measure the resistance between the front stereo component speaker and the stereo component amplifier to check for an open circuit in the wire harness.
Measure the resistance between the woofer box speaker and the stereo component amplifier to check for an open circuit in the wire harness.
Measure the resistance between the front No. 1 speaker and the front No. 2 speaker to check for an open circuit in the wire harness.
Measure the resistance between the rear stereo component speaker and the stereo component amplifier to check for an open circuit in the wire harness.
Measure the resistance between each speaker and body ground to check for a short circuit in the wire harness.
|
| ||||
| OK | |
| 2.INSPECT WOOFER BOX SPEAKER |
![]() |
Resistance check.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| 1 - 3 | Always | Approximately 1.2 Ω |
| 2 - 4 | Always | Approximately 1.2 Ω |
|
| ||||
| OK | |
| 3.INSPECT FRONT NO. 1 SPEAKER |
Resistance check.
Measure the resistance between the terminals of the speaker.
|
| ||||
| OK | |
| 4.INSPECT FRONT NO. 2 SPEAKER |
Check that the malfunction disappears when another speaker in good condition is installed.
|
| ||||
| NG | |
| 5.INSPECT REAR SPEAKER |
Resistance check.
Measure the resistance between the terminals of the speaker.
|
| ||||
| OK | |
| 6.INSPECT FRONT STEREO COMPONENT SPEAKER |
Resistance check.
Measure the resistance between the terminals of the speaker.
|
| ||||
| OK | |
| 7.INSPECT REAR STEREO COMPONENT SPEAKER |
Check that the malfunction disappears when another speaker in good condition is installed.
|
| ||||
| NG | ||
| ||