Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a reverse signal from the park/neutral position switch and information about the GPS antenna, and then adjusts vehicle position.

WIRING DIAGRAM


E120120E10


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E113510E01
  1. Disconnect the navigation receiver assembly connector R12.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    REV - Body ground
    Ignition switch is ON.
    Shift lever is moved to R position.
    10 to 14 V
    REV - Body ground
    Ignition switch is ON.
    Shift lever is moved to any position except R.
    Below 1 V



OK
REPLACE NAVIGATION RECEIVER ASSEMBLY
NG


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - PARK/NEUTRAL POSITION SWITCH)


    E120121E10
  1. Disconnect the navigation receiver assembly connector R12 and park/neutral position switch connector P1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    REV - P1-1
    Always
    Below 1 Ω
    REV - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK/NEUTRAL POSITION SWITCH


    E120122E01
  1. Disconnect the park/neutral position switch connector P1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    P1-1 - P1-2
    Shift lever is moved to R
    Below 1 Ω
    P1-1 - P1-2
    Shift lever is moved to any position except R.
    10 kΩ or higher



NG
REPLACE PARK/NEUTRAL POSITION SWITCH
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR