Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the microphone to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the microphone.

WIRING DIAGRAM


E125116E02


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E121195E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    MACC - Body ground
    Ignition SW ACC
    4 to 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR


    E113512E01
  1. Disconnect the navigation receiver assembly connector R10.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    SGND - TSW-
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (MICROPHONE - NAVIGATION RECEIVER ASSEMBLY)


    E125117E03
  1. Disconnect the microphone connector T13 and navigation receiver assembly connector R10.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    MACC - MACC
    Always
    Below 1 Ω
    MI1+ - MIC+
    Always
    Below 1 Ω
    MIC- - MIC-
    Always
    Below 1 Ω
    MACC - Body ground
    Always
    10 kΩ or higher
    MIC+ - Body ground
    Always
    10 kΩ or higher
    MIC- - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE