Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The navigation receiver assembly sends a sound signal to the stereo component amplifier through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier or speakers.

WIRING DIAGRAM


E125103E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)


    E121192E07
  1. Disconnect the connectors from the navigation receiver assembly and stereo component amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    L+ - L+
    Always
    Below 1 Ω
    L- - L-
    Always
    Below 1 Ω
    R+ - R+
    Always
    Below 1 Ω
    R- - R-
    Always
    Below 1 Ω
    SLD - Body ground
    Always
    10 kΩ or higher
    L+ - Body ground
    Always
    10 kΩ or higher
    L- - Body ground
    Always
    10 kΩ or higher
    R+ - Body ground
    Always
    10 kΩ or higher
    R- - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE