Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Sound Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The stereo jack adapter sends an external device sound signal to the navigation receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier navigation receiver assembly or speakers.

WIRING DIAGRAM


E148010E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO JACK ADAPTER)


    E174487E01
  1. Disconnect the connectors from the stereo jack adapter and navigation receiver assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    AUXO - ADPG
    Always
    Below 1 Ω
    ASGN - VA-
    Always
    Below 1 Ω
    ARO - VAR+
    Always
    Below 1 Ω
    ALO - VAL+
    Always
    Below 1 Ω
    AUXO - Body ground
    Always
    10 kΩ or higher
    ASGN - Body ground
    Always
    10 kΩ or higher
    ARO - Body ground
    Always
    10 kΩ or higher
    ALO - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE