Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Mute Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

for Preparation Click here


DESCRIPTION

The navigation receiver assembly controls the volume according to the MUTE signal from the television display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode, etc. If there is an open in the circuit, noise can be heard from the speakers when changing the sound source. If there is a short in the circuit, even though the navigation receiver assembly is normal, no sound or only an extremely small sound can be produced.

WIRING DIAGRAM


E110892E37


INSPECTION PROCEDURE

1.INSPECT TELEVISION DISPLAY ASSEMBLY


    E113507E02
  1. Disconnect the television display assembly T14 connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    MUTE - Body ground
    Turn ignition switch to ACC, RSE system is playing → Changing mode
    Above 3.5 V → Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)


    E121191E06
  1. Disconnect the navigation receiver assembly R14 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    R14-6 (MUTE) - T14-26 (MUTE)
    Always
    Below 1 Ω
    MUTE - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEVISION DISPLAY ASSEMBLY
  1. Replace the television display assembly and check if it operates normally.

    OK:
    The navigation system operates normally.



OK
NORMAL OPERATION
NG

REPLACE NAVIGATION RECEIVER ASSEMBLY