Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Navigation Voice Circuit

for Preparation Click here


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on.

WIRING DIAGRAM


E119672E10


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)


    E121188E05
  1. Disconnect the navigation receiver assembly connector R13 and stereo component amplifier connector S11.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    IVO+ - INT+
    Always
    Below 1 Ω
    IVO- - INT-
    Always
    Below 1 Ω
    IVO+ - Body ground
    Always
    10 kΩ or higher
    IVO- - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE