Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Vehicle Speed Signal Circuit between Navigation Receiver Assembly and Combination Meter

for Preparation Click here


DESCRIPTION

The navigation receiver assembly receives a vehicle speed signal from the combination meter and information about the GPS antenna, and then adjusts vehicle position.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM


E159203E01


INSPECTION PROCEDURE

1.CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer on the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E113510E18
  1. Disconnect the navigation receiver assembly connector R12.



  1. Measure the voltage.

    1. Jack up either one of the drive wheels.

    2. Move the shift lever to the neutral position.

    3. Turn the ignition switch to the ON position.



    4. E110855E01
    5. Measure the voltage between terminal SPD of the navigation receiver assembly and body ground when the drive wheels are turned slowly.

      OK:
      Voltage pulses as shown in the illustration.



OK
REPLACE NAVIGATION RECEIVER ASSEMBLY
NG


3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - NAVIGATION RECEIVER ASSEMBLY)


    E125114E03
  1. Disconnect the navigation receiver assembly connector R12 and combination meter connector C10.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    SPD - C10-36
    Ignition switch off
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (COMBINATION METER - NAVIGATION RECEIVER ASSEMBLY)


    E125114E03
  1. Disconnect the navigation receiver assembly connector R12 and combination meter connector C10.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    SPD - Body ground
    Ignition switch off
    10 kΩ or higher

    HINT:
    If the resistance between terminal SPD and body ground is less than 10 kΩ, there may be a short in a wire harness, connector, or an ECU.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR OR CHECK EACH ECU
OK

REPLACE COMBINATION METER