Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends a sound signal to the radio receiver through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier or radio receiver (built-in amplifier), and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier, radio receiver, or speakers.

WIRING DIAGRAM


E120034E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY ASSEMBLY)


    E120035E03
  1. Disconnect the connectors from the television display assembly and radio receiver.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    CDR+ - R+
    Always
    Below 1 Ω
    CDR- - R-
    Always
    Below 1 Ω
    CDL+ - L+
    Always
    Below 1 Ω
    CDL- - L-
    Always
    Below 1 Ω
    CSLD - SLD9
    Always
    Below 1 Ω
    R- - Body ground
    Always
    10 kΩ or higher
    L+ - Body ground
    Always
    10 kΩ or higher
    L- - Body ground
    Always
    10 kΩ or higher
    R+ - Body ground
    Always
    10 kΩ or higher
    SLD9 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT TELEVISION DISPLAY ASSEMBLY


    E120036E03
  1. Reconnect the television display assembly connector.

  1. Check the waveform according to the conditions shown in the table below.


Standard:

Tester connection
Condition
Specified condition
R+ - Body ground
Voice sound is being produced
A waveform synchronized with sound is output
R- - Body ground
Voice sound is being produced
A waveform synchronized with sound is output
L+ - Body ground
Voice sound is being produced
A waveform synchronized with sound is output
L- - Body ground
Voice sound is being produced
A waveform synchronized with sound is output



NG
REPLACE TELEVISION DISPLAY ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE