Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The radio receiver controls the volume according to the MUTE signal from the television display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when switching the mode, etc.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the radio receiver is normal, no sound or, only an extremely small sound, can be produced.

WIRING DIAGRAM


E110892E13


INSPECTION PROCEDURE

1.INSPECT TELEVISION DISPLAY ASSEMBLY


    E120036E04
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    MUTE - Body ground
    Turn ignition switch to ACC, RSE system is playing → Changing mode
    Above 3.5 V → Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - TELEVISION DISPLAY)


    E120035E04
  1. Disconnect the radio receiver connector and the television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    MUTE - MUTE
    Always
    Below 1 Ω
    MUTE - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEVISION DISPLAY ASSEMBLY
  1. Replace the television display assembly and check if the audio system operates normally.

    OK:
    The audio system operates normally.



OK
END
NG

REPLACE RADIO RECEIVER