SFI SYSTEM > READINESS MONITOR DRIVE PATTERN |
| PURPOSE OF READINESS TESTS |
| Steps | Section Titles |
| 1 | Catalyst Monitor (Active Air-Fuel Ratio Control Type) |
| 2 | EVAP System Monitor (Key-Off Type) |
| 3 | Air-Fuel Ratio (A/F) and Heated Oxygen (HO2) Sensor Monitors (Active Air-Fuel Ratio Control Type) |
| 4 | Air-Fuel Ratio (A/F) and Heated Oxygen (HO2) Sensor Heater Monitors (Front A/F and Rear HO2 Sensor Type) |
| CATALYST MONITOR (ACTIVE AIR-FUEL RATIO CONTROL TYPE) |

Preconditions
Drive Pattern
Connect the Techstream.
Turn the ignition switch to the ON position.
Turn the tester or scan tool ON.
Clear the DTCs.
Start the engine and warm it up.
Drive the vehicle at between 40 mph and 70 mph (64 km/h and 113 km/h) for at least 10 minutes.
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to Complete, extend the driving time.
| EVAP MONITOR (KEY-OFF TYPE) |
Preconditions
Monitor Conditions
Turn the ignition switch off and wait for 6 hours.
Monitor Status
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester or scan tool ON.
Check the Readiness Monitor status displayed on the tester or scan tool.
If the status does not switch to Complete, restart the engine, make sure that the preconditions have been met, and then perform the Monitor Conditions again.
| A/F SENSOR AND HO2S MONITORS |
Preconditions
Drive Pattern for front A/F sensor and HO2 sensor.
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Clear the DTCs.
Start the engine, and warm it up until the ECT reaches 75°C (167°F) or higher.
Drive the vehicle at 38 mph (60 km/h) or more for at least 10 minutes.
Change the transmission to the 2nd gear.
Accelerate the vehicle to 40 mph (64 km/h) or more by depressing the accelerator pedal for at least 10 seconds (Procedure "A").
Soon after performing procedure "A" above, release the accelerator pedal for at least 4 seconds without depressing the brake pedal, in order to execute fuel-cut control (Procedure "B").
Allow the vehicle to decelerate until the vehicle speed declines to less than 6 mph (10 km/h) (Procedure "C").
Repeat procedures from "A" through "C" above at least 3 times in one driving cycle.
Monitor Status
Check the Readiness Monitor status displayed on the tester.
If the status does not switch to Complete, make sure that the preconditions have been met and then perform the Drive Pattern again.

| AIR-FUEL RATIO (A/F) AND HEATED OXYGEN (HO2) SENSOR HEATER MONITORS (FRONT A/F AND REAR HO2 SENSOR TYPE) |

Preconditions
Drive Pattern
Connect the Techstream to the DLC3.
Turn the ignition switch to the ON position.
Clear the DTCs.
Start the engine.
Allow the engine to idle for 10 minutes or more.
Drive the vehicle at 25 mph (40 km/h) or more for at least 2 minutes.
Monitor Status
Check the Readiness Monitor status displayed on the tester or scan tool.
If the status does not switch to Complete, make sure that the preconditions have been met, and repeat the Drive Pattern.