Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here


NOTICE:
Before removing the tire pressure warning ECU, read the registered transmitter IDs of all wheels and write them down to use for re-registration of transmitter IDs (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

HINT:
Refer to the instructions for REMOVAL of the instrument panel safety pad (Click here).



3. REMOVE TIRE PRESSURE WARNING ECU


    C156706
  1. Remove the screw.



    C156707
  1. Disconnect the connector and remove the tire pressure warning ECU.