Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)

REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side) > ADJUSTMENT

for Preparation Click here


HINT:
If the malfunction does not disappear by following the procedure in ADJUSTMENT and the rear No. 2 seat assembly needs to be replaced, do not disassemble the rear No. 2 seat assembly.



1. ADJUST FRONT LEG


HINT:
Perform the following procedure if the inner leg does not lock.



B145731E01



    B145732E01
  1. Push down on the rear No. 2 seat assembly to lock the front leg.



  1. Loosen the bolt on the front leg that has locked and move the rear No. 2 seat assembly up and down a few times.

    NOTICE:
    Check that the front leg plate moves.



    B145733E01



    B145734E01
  1. Tighten the bolt.

    Torque:
    14.5 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Hold the nut to prevent it from turning.

  1. Check that the rear No. 2 seat assembly operates normally and both front legs lock securely.

    NOTICE:
    If any of the front legs do not lock, loosen the bolt on the front leg that has not locked, and perform the procedure from (b) again.



2. REINSTALL REAR NO. 2 SEAT ASSEMBLY

HINT:
Perform the following procedure if the rear No. 2 seat assembly is removed with any of the 4 legs released or if the rear legs are moved with the rear No. 2 seat assembly removed.

  1. Remove the following components:

    1. Rear No. 2 seat leg side garnish sub-assembly

    2. Rear seat leg garnish sub-assembly

    3. No. 2 seat hinge cover

    4. Rear No. 2 seat assembly



    B146293E01
  1. Lock the rear legs to the striker.

  1. Lock the front legs to the striker.



    B146294E01
  1. If any of the front legs do not lock, perform the following procedure:

    1. Connect the connector.



    2. B146295E01
    3. Operate the stowing/return switch to set the rear legs to the most upright position.



    4. B146296
    5. Lock the front legs to the striker.

  1. Align the links of the No. 2 seat leg sub-assembly with the No. 2 seat cushion frame sub-assembly.



  1. Align the screw holes on the No. 2 cushion frame sub-assembly with the square link holes on the No. 2 seat leg sub-assembly.

    HINT:
    If the holes do not align, move the No. 2 seat cushion frame sub-assembly horizontally to align the holes.



    B145735E01



  1. Operate the stowing/return switch to adjust the rear legs so that the rear legs fit to the links of the No. 2 seat leg sub-assembly as shown in the illustration.


    B146297E01



    B126838E01
  1. Install the 8 bolts.

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order shown in the illustration.

  1. Install the following components:

    1. No. 2 seat hinge cover

    2. Rear seat leg garnish sub-assembly

    3. Rear No. 2 seat leg side garnish sub-assembly

  1. Check that the rear No. 2 seat assembly operates normally and the rear legs lock securely.

    NOTICE:
    If any of the front legs do not lock normally, perform the procedure in "1. ADJUST FRONT LEG".