Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DRAIN ENGINE COOLANT


  1. Loosen the radiator drain cock plug.


    A161473E01

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

    NOTICE:
    Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the 2 cylinder block drain cock plugs.



2. REMOVE V-BANK COVER SUB-ASSEMBLY


    A162365
  1. Hold the front of the V-bank cover and raise it to disengage the 2 clips on the front of the cover. Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.

    NOTICE:
    Attempting to disengage both front and rear clips at the same time may cause the cover to break.



3. REMOVE NO. 2 AIR CLEANER INLET


    A133004
  1. Disconnect the vacuum switching valve clamp.

  1. Disconnect the 2 vacuum hoses.

  1. Remove the 2 bolts and No. 2 air cleaner inlet.



4. REMOVE NO. 1 AIR CLEANER INLET


    A155040
  1. Remove the bolt and No. 1 air cleaner inlet.



5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A135112E01
  1. Disconnect the 3 vacuum hoses.



    A135113E01
  1. Remove the No. 2 ventilation hose and air cleaner hose band.

  1. Disconnect the vacuum hose (EVAP) from the air cleaner hose.



    A135114
  1. Disconnect the mass air flow meter connector.

  1. Remove the 2 bolts and air cleaner cap sub-assembly.



6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    A155039
  1. Disconnect the vacuum switching valve connector.

  1. Disconnect the vacuum hose.

  1. Remove the 3 bolts and air cleaner case.



7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A162197
  1. Remove the engine coolant temperature sensor connector.

  1. Remove the engine coolant temperature sensor.