AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver |

| 1.INSPECT RADIO RECEIVER |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MCVD - Body ground | Ignition switch ACC | 4 to 6 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BODY GROUND) |
![]() |
Disconnect the radio receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| TSW- - SGND | Always | Below 1 Ω |
| TSW- - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (MICROPHONE - RADIO RECEIVER) |
![]() |
Disconnect the microphone connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| MCVD - MACC | Always | Below 1 Ω |
| MIC+ - MI1+ | Always | Below 1 Ω |
| MIC- - MIC- | Always | Below 1 Ω |
| MCVD - Body ground | Always | 10 kΩ or higher |
| MIC+ - Body ground | Always | 10 kΩ or higher |
| MIC- - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||