AUDIO AND VISUAL SYSTEM > Bluetooth Handsfree Module Communication Error |
| 1.IDENTIFY THE COMPONENT SHOWN BY SUB-CODE |
Enter the diagnostic mode.

Press the preset switch "3" to change to "Detailed Information Mode".
Identify the component shown by the sub-code.
| NEXT | |
| 2.CHECK COMPONENT SHOWN BY SUB-CODE |
Select the component shown by sub-code.
| Component | Proceed to |
| Radio Receiver (190) | A |
| Except Radio Receiver | B |
|
| ||||
| B | |
| 3.CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
| Television display assembly (1B0) | Television display assembly power source circuit (Click here) |
| Stereo component amplifier (440) | Stereo component amplifier power source circuit (Click here) |
| NEXT | |
| 4.INSPECT RADIO RECEIVER |
![]() |
Disconnect the radio receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ATX+ (R7-5) - ATX- (R7-15) (*1) | Always | 60 to 80 Ω |
| TXM+ (R8-9) - TXM- (R8-10) | Always | 60 to 80 Ω |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR ("BLUETOOTH" HANDSFREE MODULE - COMPONENT SHOWN BY SUB-CODE) |
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.
Disconnect all connectors between the "Bluetooth" handsfree module and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the "Bluetooth" handsfree module and the component shown by the sub-code.

|
| ||||
| OK | |
| 6.REPLACE COMPONENT SHOWN BY SUB-CODE |
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
|
| ||||
| OK | ||
| ||