Home › ENGINE › 2GR-FE COOLING › RADIATOR

RADIATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE RADIATOR WATER INLET


    A161477
  1. Remove the 2 bolts and radiator water inlet.



2. REMOVE DRAIN PLUG
  1. Remove the drain plug and air drain plug.

  1. Remove the 2 O-rings.



3. REMOVE LOWER RADIATOR TANK


    A113337E02
  1. Install the claw to the overhaul handle, inserting it in the hole in Part A as shown in the illustration.

    SST
    09230-01010   (09231-01010, 09231-01030)

  1. While squeezing the handle, adjust the stopper bolt so that dimension B is as specified below.

    Dimension B:
    0.2 to 0.3 mm (0.008 to 0.012 in.)

    NOTICE:
    If the stopper bolt is not adjusted, the claw may be damaged.



    A162775E01
  1. Using SST, uncrimp the lock plate by squeezing the handle until stopped by the stopper bolt.

    SST
    09230-01010  



    A162776
  1. Lightly tap the bracket of the radiator (or radiator hose inlet or outlet) with a soft-faced hammer and remove the tank.

  1. Remove the O-ring.



4. REMOVE UPPER RADIATOR TANK

HINT:
The removal procedure for the upper radiator tank is the same as that for the lower radiator tank.