RADIATOR > REASSEMBLY |
| 1. INSTALL LOWER RADIATOR TANK |
![]() |
After checking that there are no foreign objects in the lock plate groove, install a new O-ring without twisting it.
![]() |
Tap the lock plate with a plastic-faced hammer so that there is no gap between the lock plate and the tank.
![]() |
Install the punch assembly to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
While gripping the handle, adjust the stopper bolt so that dimension B is as specified below.
![]() |
Lightly press SST against the lock plate in the order shown in the illustration. After repeating this procedure a few times, fully crimp the lock plate by squeezing the handle until stopped by the stopper bolt.
![]() |
![]() |
![]() |
Check the lock plate height A after completing the crimping.
| 2. INSTALL UPPER RADIATOR TANK |
| 3. INSTALL DRAIN PLUG |
Install a new O-ring to the drain plug.
Install a new O-ring to the air drain plug.
Install the drain plug and air drain plug.
| 4. INSPECT FOR WATER LEAK |
![]() |
Plug the inlet and outlet pipes of the radiator with SST.
Using a radiator cap tester, apply pressure to the radiator.
Submerge the radiator in water.
![]() |
Inspect for leak.
| 5. INSTALL RADIATOR WATER INLET |
![]() |
Install the radiator water inlet with the 2 bolts.