Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


SYSTEM DESCRIPTION

This circuit is used when an incoming cellular phone voice in the "Bluetooth" handsfree system is received.

WIRING DIAGRAM


E155782E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E155784E01
  1. Disconnect the radio receiver connector and the stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    IVO+ - INT+
    Always
    Below 1 Ω
    IVO- - INT-
    Always
    Below 1 Ω
    IVO+ - Body ground
    Always
    10 kΩ or higher
    IVO- - Body ground
    Always
    10 kΩ or higher
    SLD1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE