Home › ENGINE › 2GR-FE LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A162362
  1. Remove the 8 bolts, 4 clips and No. 1 engine under cover assembly.



2. REMOVE EXHAUST PIPE ASSEMBLY
for 2WD:(Click here)
for 4WD:(Click here)


3. DRAIN ENGINE COOLANT


  1. Loosen the radiator drain cock plug.


    A161473E01

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Remove the radiator cap sub-assembly from the radiator assembly.

    NOTICE:
    Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the 2 cylinder block drain cock plugs.



4. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug, and drain the oil into a container.

  1. Clean and install the oil drain plug with a new gasket.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



5. REMOVE NO. 2 MANIFOLD STAY


    A140783
  1. Remove the bolt, nut and No. 2 manifold stay.



6. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    A140784
  1. Remove the 3 bolts and No. 2 insulator.



7. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    A129641
  1. Uniformly loosen and remove the 6 nuts.

  1. Remove the manifold and gasket.



8. REMOVE ENGINE OIL COOLER


    A136291
  1. Remove the bolt, 2 clamps, and 4 clips and disconnect the 2 water by-pass hoses.



    A136292
  1. Remove the oil cooler union bolt, oil cooler assembly, and O-ring.