OIL AND OIL FILTER > REPLACEMENT |
| 1. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the oil drain plug, and drain the oil into a container.
Clean and install the oil drain plug with a new gasket.
| 2. REMOVE OIL FILTER ELEMENT |
![]() |
Connect the hose with an inside diameter of 15 mm (0.59 in.) to the pipe.
![]() |
Remove the oil filter drain plug from the oil filter cap.
![]() |
Insert the pipe with the hose into the oil filter cap.
![]() |
Make sure that oil is completely drained, and remove the pipe and O-ring.
![]() |
Using SST, remove the oil filter cap.
![]() |
Remove the oil filter element and O-ring from the oil filter cap.
| 3. INSTALL OIL FILTER ELEMENT |
![]() |
Clean the inside of the oil filter cap, threads, and O-ring groove.
Apply a light coat of engine oil to a new O-ring and install it to the oil filter cap.
Install a new oil filter element to the oil filter cap.
Remove all dirt and foreign matter from the installation surface and the inside of the cap on the engine side.
Apply a light coat of engine oil to the O-ring again and install the oil filter cap.
![]() |
Using SST, install the oil filter cap.
![]() |
Apply a light coat of engine oil to a new O-ring and install it to the oil filter cap.
Install the oil filter drain plug to the oil filter cap.
| 4. ADD ENGINE OIL |
Add clean engine oil and install the oil filler cap.
| Oil Grade | Oil Viscosity (SAE) |
| ILSAC multigrade engine oil | 5W-30 |
| Item | Standard Condition |
| Drain and refill with oil filter change | 6.1 liters (6.4 US qts, 5.4 lmp. qts) |
| Drain and refill without oil filter change | 5.7 liters (6.0 US qts, 5.0 lmp. qts) |
| Dry fill | 7.1 liters (7.5 US qts, 6.2 lmp. qts) |
| 5. INSPECT FOR OIL LEAK |
Start the engine. Check for engine oil leaks from the connected parts of the oil filter cap and oil filter drain plug.