OIL PUMP > INSPECTION |
| 1. INSPECT OIL PUMP RELIEF VALVE |
![]() |
Coat the relief valve with engine oil and check that it falls smoothly into the valve hole under its own weight.
If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.
| 2. INSPECT OIL PUMP ROTOR SET |
![]() |
Install the rotors to the timing chain cover with the rotors' marks facing outward. Check that the rotors rotate smoothly.
![]() |
Check the tip clearance.
Using a feeler gauge, measure the clearance between the drive and driven rotors, as shown in the illustration.
| Standard | Maximum |
| 0.060 to 0.160 mm (0.0024 to 0.0063 in.) | 0.160 mm (0.0063 in.) |
![]() |
Check the side clearance.
Using a feeler gauge and precision straightedge, measure the clearance between the rotors and precision straightedge, as shown in the illustration.
| Standard | Maximum |
| 0.030 to 0.090 mm (0.0012 to 0.0035 in.) | 0.090 mm (0.0035 in.) |
![]() |
Check the body clearance.
Using a feeler gauge, measure the clearance between the timing chain cover and driven rotor, as shown in the illustration.
| Standard | Maximum |
| 0.250 to 0.325 mm (0.0098 to 0.0128 in.) | 0.325 mm (0.0128 in.) |