Home › ENGINE › 2GR-FE INTAKE › INTAKE AIR CONTROL VALVE

INTAKE AIR CONTROL VALVE > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTAKE AIR SURGE TANK ASSEMBLY


  1. Inspection procedure when applying voltage between the terminals:

    1. Disconnect the connector from the intake air control valve.



    2. A142732
    3. Apply battery voltage between terminals 1 (-) and 2 (+) of the intake air control valve. Check that a clicking sound is heard from the intake air control valve.
      If the result is not as specified, replace the intake air surge tank.