Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › NETWORK GATEWAY ECU

NETWORK GATEWAY ECU > INSTALLATION

for Preparation Click here



1. INSTALL NETWORK GATEWAY ECU


    C161438
  1. Install the network gateway ECU with the nut.

  1. Connect the connector.



2. INSTALL CLEARANCE WARNING ECU ASSEMBLY


    E146348
  1. Install the clearance warning ECU with the nut.

  1. Connect each connector.



3. INSTALL PANEL SAFETY PAD INSERT NO. 1


4. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH


5. REMOVE COWL SIDE TRIM BOARD LH


6. REMOVE FRONT DOOR SCUFF PLATE LH